Electrical Design Software | Elecdes Design Suite by Scada Systems Ltd

How to Copy a Circuit and rename symbols

Fundamentals

The Copy Circuit function enables you to copy and paste a circuit incrementing the TAGNAME attribute the TAGNAMES of the all the components in the selected circuit. When you use this function, Elecdes scans the whole project and increments TAGNAME of each component in the pasted circuit to the next available TAGNAME. This can be very useful when you have to copy a circuit several times in a drawing without worrying about incrementing the TAGNAMES attribute manually.

The copy circuit can be used for whole circuit, part of circuit or a single component.

For using the copy circuit you need to make sure that you have enabled the appropriate settings for Rename Symbols after COPY Command from Elecdes Preferences.

Procedure

  1. Select Copy Circuit from the Elecdes > Utility menu.

    OR you can type COPY in the command line and press <ENTER>.

  2. You will be presented with an AutoCAD selection cursor as shown in the figure below.

  3. You should select a circuit from the drawing and press <ENTER>.

  4. You can drag your selected are and pick a new location for pasting your circuit. You can paste your circuit as many times as you like in your drawing. Once you are finished pasting press <ENTER>.

  5. Elecdes will automatically rename TAGNAME of every component in your pasted circuit to the next available TAGNAME in the project.

    The figure below shows the result after pasting the circuit. You will find that all the components have been renamed.

  6. If you have selected the option to Ask before renaming the copied symbols in the settings Rename Symbols after COPY Command from Elecdes Preferences then Elecdes will show you a multiple choice dialog as shown below.

    • If you do not want to change any of the pasted symbols then choose Do not rename copies of symbols.
    • If you do not want to stop this dialog showing again you can click on Never Rename copies of symbols.
    • If you want to rename the pasted symbols then choose Rename copies of symbols.
    • If you do not want to see this dialog and always rename the copies symbols then click on Always rename copies of symbols.