Electrical Design Software | Elecdes Design Suite by Scada Systems Ltd

Riser: Conduit

In the picture the first end of the segment is at the bottom-left.

While it is technically possible to define a conduit riser, there is usually no benefit when compared to using a conduit corner for all conduit bends, both horizontally and vertically oriented.

Catalog DBF FieldDescriptive Field NameDescription
CLASSCLASSMust be set to CONDRSR.
RADIUSRADIUSOuter radius of the conduit pipe.
SECHEIGHTWALL THICKNESSThickness of the conduit pipe wall.
BNDRADIUSBEND RADIUSThe radius to the inside edge of the corner.
CNRANGLECORNER ANGLE

The inside angle of the riser = ( 180° - deviation from straight ).

e.g. "150" for a riser that deviates 30° from straight.

LENGTH1EXTENSION 1Straight extension at the first end.
LENGTH2EXTENSION 2Straight extension at the second end.
LENGTH5UNTRIMMED CNRANGLE

The original inside angle of the segment before trimming to the required angle.

This value is set from the CNRANGLE field of the catalog item when it is inserted.

This field should be empty in a catalog record.