Electrical Design Software | Elecdes Design Suite by Scada Systems Ltd

Corner: Conduit

In the picture the first end of the segment is at the bottom-left.

A conduit corner will usually suffice for all conduit bends, both horizontally and vertically oriented. There is usually no benefit to defining a conduit riser.

Catalog DBF FieldDescriptive Field NameDescription
CLASSCLASSMust be set to CONDCNR.
RADIUSRADIUSOuter radius of the conduit pipe.
SECHEIGHTWALL THICKNESSThickness of the conduit pipe wall.
BNDRADIUSBEND RADIUSThe radius to the inside edge of the corner.
CNRANGLECORNER ANGLE

The inside angle of the corner = ( 180° - deviation from straight ).

e.g. "150" for a corner that deviates 30° from straight.

LENGTH1EXTENSION 1Straight extension at the first end.
LENGTH2EXTENSION 2Straight extension at the second end.
LENGTH5UNTRIMMED CNRANGLE

The original inside angle of the segment before trimming to the required angle.

This value is set from the CNRANGLE field of the catalog item when it is inserted.

This field should be empty in a catalog record.