Riser: Duct, Tray, Trench
In the picture the first end of the segment is at the bottom-left.
|Catalog DBF Field
|Descriptive Field Name
|Must be set to DUCTRSR, TRAYRSR, or TRENCHRSR.
|The height of the riser.
|The width of the riser.
|The radius to the inside edge of the riser.
The inside angle of an inside riser = ( 180° - deviation from straight ).
"150" for an inside riser that rises 30° up from straight.
The outside angle of an outside riser = ( 180° + deviation from straight ).
"210" for an outside riser that drops 30° down from straight.
|The thickness of the base to the inner cavity.
|SIDE WALL THICKNESS
|The thickness of each wall to the inner cavity.
|Straight extension at the first end.
|Straight extension at the second end.
The original inside angle of the segment before trimming to the required angle.
This value is set from the CNRANGLE field of the catalog item when it is inserted.
This field should be empty in a catalog record.