Electrical Design Software | Elecdes Design Suite by Scada Systems Ltd

How to Reference a Conductor that Appears on Multiple Sheets


If you have continued a conductor across multiple sheets using the conductor extension marker, you may generate sequential references across the sheets rather than referencing each conductor from a table. The conductor extension markers will be referenced in pairs from sheet to sheet in alphabetic drawing name order. You must have balanced pairs of conductor markers. Standard (non-extension) markers will not be referenced.

By default only conductor extension pairs will cross reference. You must disable this setting to get standard conductor markers to cross reference.


  1. Go to the Options tab page.

  2. Tick or untick Ref Cond Extn Only to enable or disable this option. By default this option is enabled

If you have more than one conductor extension marker for a conductor on a single sheet, then you can specify the priority for sorting two or more conductors with the Priority options shown below.