How to Reference a Conductor that Appears on Multiple Sheets
General
If you have continued a conductor across multiple sheets using the conductor extension marker, you may generate sequential references across the sheets rather than referencing each conductor from a table. The conductor extension markers will be referenced in pairs from sheet to sheet in alphabetic drawing name order. You must have balanced pairs of conductor markers. Standard (non-extension) markers will not be referenced.
By default only conductor extension pairs will cross reference. You must disable this setting to get standard conductor markers to cross reference.
Procedure
-
Go to the Options tab page.
-
Tick or untick Ref Cond Extn Only to enable or disable this option. By default this option is enabled
If you have more than one conductor extension marker for a conductor on a single sheet, then you can specify the priority for sorting two or more conductors with the Priority options shown below.