How to Configure the General Arrangement Settings

Select Preferences from the Paneldes Menu. Choose the General Arrangement tab at the top of the dialog.

2D General Arrangement

Space between exploded plates	The amount of space to leave between exploded plates. This value must have units.
Item attached to plate tolerance	A tolerance value which is used when determining if a component is mounted on a plate. This value must have units. Increase this value if you find that you components are not being attached to plates when exploding or rebuilding your panel.
Viewport title text height	The height of the viewport label text in drawing units.

Spacing From Plate	How far the dimension line is from the edge of the plate. This value must have units.
Inter-Dim. Spacing	The spacing between stacked dimensions in drawing units. See Baseline dimensions spacing in the AutoCAD help.
Extn.Above Line	How much to extend the extension line beyond the dimension line. See Extension Lines in the AutoCAD help for more information.
Extn.Line origin offset	How much to offset the extension line from the object being dimensioned. See Extension Lines in the AutoCAD help for more information.
Scale all dim sizes	The overall scale of the dimensions. This effects all settings. See dimension scale in the AutoCAD help for more information.
Dimension text height	The height of the dimension text in drawing units
Decimal point separator	The decimal point separator character
Decimal places	The number of decimal places to show on dimensions
Dimension units	The units to use for dimensions
Text inside extension is horizontal	Specifies the orientation of the dimension text. See dimension text alignment in the AutoCAD help for more information